3D Solex UM2 Conversion Kit 1,75 mm Nano

With this kit you can convert your Ultimaker 2 or 2+ Ultimaker completely to a 1.75mm filament.

• The upgrade almost halves the printing time. With an additional heater upgrade, the printing time can be reduced to as much as 25%.
• However, a heater upgrade is not necessary to achieve an extrusion of 25 mm3 / sec.
• The formula for the calculation is as follows: nozzle diameter x layer height x speed. (Ultimaker 2 standard corresponds to approximately 8 mm3 / sec)
• Nozzle achieves higher print speeds at lower temperatures.
• The contact area between the block and the nozzle was greatly enlarged for better heat distribution!

Includes:

• Matchless V3 block 1,75mm filament
• Matchless nozzle 0.4 mm for 1.75 mm filaments
• Bowden Tube 1.75mm
• PTFE Coupler for 1.75 mm filaments