2 English reviews written for 3DJAKE ecoPLA Refill White
5 customer reviews in all languages
5 stars | | 4 | (44%) |
---|---|---|---|
4 stars | | 2 | (22%) |
3 stars | | 2 | (22%) |
2 stars | | 0 | (0%) |
1 Stars | | 1 | (11%) |
Filter reviews:
-
-
Good filament, bad spool winding
Rated with 4 out of 5 stars.
Material is awesome and produces good looking parts. But the way the spool comes loosely held together with loose zip ties makes me uneasy when printing long hours. I am constantly paranoid about the filament getting stuck on the spool but luckily that hasn't happened yet. Still, even placing the filament on the master spool needs great care as to not unravel the whole thing and end up with a filament mess. There are refill spools with better windings out there in my opinion but 3D Jakes's is cheaper and when buying enough to enable free shipping, I'll keep buying these. But only if the bad spool winding doesn't cause problems down the road where I'm forced to waste material.
Was this rating helpful? (0) (0)
Magazine Articles:
Discover 3DJake:
-
Free delivery in Great Britain
from £59.90 -
Free
returns More than 9.100 products
Secure payments
with SLL encryption technology
Bubbly Bendy PLA
Rated with 3 out of 5 stars.
It was completely unusable out of the wrap because of moisture. The wrap it came in had ripped from the sides, allowing moisture in. During printing it bubbled and bent a lot. After few hours in the oven at 60-70 degrees Celsius it was good again and didn't bubble, but it had become rigid. Later I realized it was a boon since I didn't have big enough spool for it, so the rigidness helped with the intake in my extruder. It was still a little bendy but nothing that would have ruined a print.
I guess it's fine if you don't mind some wet work.
Was this rating helpful? (0) (0)