3 English reviews written for FormFutura EasyWood™ Coconut
10 customer reviews in all languages
| 5 stars | | 8 | (42%) |
|---|---|---|---|
| 4 stars | | 4 | (21%) |
| 3 stars | | 4 | (21%) |
| 2 stars | | 1 | (5%) |
| 1 Stars | | 2 | (10%) |
Filter reviews:
-
Dan T.
11 March 2022
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. -
Travis
26 October 2019
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. Decent filament
Rated with 4 out of 5 stars.
First wood filament I've used and now after sitting down to get the settings dialed in, it's printing well.
I will say it's been a bit of a pain to get it dialed in but that doesn't seem to be just this wood filament as most wood ones I've seen people have said they're always that way
Anyways, in case a Prusa i3 mk3s user gets this here's the settings I used to get it dialed pretty decently
Nozzle: 0.4
PrusaSlicer Settings:
Filament Settings:
Temp:
-Extruder - First Layer:215 : Other layers:215
Printer Settings:
Retraction:
-Length: 7.5mm
-Retraction Speed: 70mm.
This made the amount of stringing I experienced very minimal. You can probably go down to 7mm on Retraction Length, and maybe 60-65mm on Speed.Was this rating helpful? (5) (0)
-
Tony
28 August 2019
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. Too soft and fragile
Rated with 2 out of 5 stars.
This filament is so soft that my CR-X, on its softest setting, crushes the filament into a flattened shape that eventually binds in the tube, until the filament just can't feed and gets chewed up.
It's taken a while of messing with settings to get to the bottom of what was happening here. If I'm lucky I can do one small 17 min print before the tubes needs pulling off and clearing out.
I have never had so much trouble with a filament before!
It's very fragile too. Easy to snap when handling. Won't be buying a wood filament again, that's for sure...Was this rating helpful? (2) (0)
Magazine Articles:
Discover 3DJake:
-
Great Britain: Free standard delivery from £59.90
-
Free
returns More than 10.500 products
We deliver worldwide to
more than 40 countries
Wrecked my nozzle on the first layer!
Rated with 1 out of 5 stars.
I couldn't even print a single layer with this filament before it irrevocably bunged up my nozzle.
I was using a 0.4mm nozzle, and the recommended temperature settings. The print started fine, but when I cam back five minutes later my print bed was covered in brown tar and nothing was printing. After spending half an hour trying to clean the nozzle, I cam to the conclusion that it's junked.
Terrible stuff. :(
Was this rating helpful? (0) (0)